Your trusted plumber in Southsea

Inspection of the boiler to identify the fault, replacement of faulty parts such as thermostats, valves or heating elements, pressure checks, and testing to confirm the boiler works safely.

When you need it. The boiler won't ignite, cuts out mid-cycle, loses pressure, makes unusual noises, or shows a fault code.

Before you get in touch. Note the boiler model and age if you know it. Check if the pilot light is lit. Look for any error codes displayed.

Rapid attendance to locate the source of the leak, isolate the water supply if needed, make temporary or permanent repairs, and check for damage to pipes, joints or fittings.

When you need it. Water is actively leaking from pipes, joints, radiators, or visible from ceilings or walls.

Before you get in touch. Turn off the water supply at the stopcock. Mop up standing water. Note where the leak is coming from.

Camera inspection to locate the blockage, mechanical clearance using rods or suction equipment, flushing to clear debris, and advice on preventing future blockages.

When you need it. Water drains slowly or won't drain at all from sinks, baths, showers or toilets.

Before you get in touch. Remove any visible debris from the drain opening. Note which drains are affected and when they started backing up.

System design and pipework installation, radiator fitting and balancing, boiler installation and connection, thermostat setup, pressure testing, and commissioning of the complete system.

When you need it. Heating system is unreliable, radiators heat unevenly, the system needs upgrading or is being installed new.

Before you get in touch. Measure the rooms needing heat. Locate the water stopcock. Note the current heating setup if one exists.

Removal of old bathroom suites, installation of new baths, showers, basins and toilets, waste pipe connection, water supply pipework, sealing and finishing work.

When you need it. Bathroom is being renovated or suites are leaking, damaged or outdated.

Before you get in touch. Measure the space. Confirm water supply location and waste pipe location. Have suites chosen in advance.

Repair or replacement of taps, ball valves, washers, stopcocks, waste fittings and other plumbing components. Includes leak repairs and minor system modifications.

When you need it. Taps drip constantly, pipes leak, cisterns run continuously, or connections need replacing.

Before you get in touch. Isolate the water supply if safe to do so. Identify which fitting or section needs work. Check for visible damage.